山东山汽工程机械(集团)有限公司
热线电话:400-879-1999 山汽官方微信
郑重声明 购机 售后
在线询价
您现在所在的位置: 首页> 全自动上料搅拌车 > 行业新闻 >

搅拌机散热器的使用方式是怎样操作的?

所属分类:行业新闻 发布时间:2020-08-19 来源:http://www.shanqijituan.com 浏览量:18

  正确运用搅拌机有利于施工的顺利进行,而且可以进步工程工作效率,如果没有正确运用会损害设备的机械部件,削减它的运用寿命。运用时的重中之中是要严格依照运用说明进行操作,一般在夏日如果全自动上料搅拌机温度过高应该立刻停下来,等温度降下来后再继续运用。今日就让小编为我们简略介绍一下全自动上料搅拌机散热器的正确运用方式:
  The correct use of automatic feeding mixer is conducive to the smooth construction, and can improve the efficiency of the project. If not properly used, it will damage the mechanical parts of the equipment and reduce its service life. The most important thing is to operate in strict accordance with the operation instructions. In summer, if the temperature of the automatic feeding mixer is too high, it should stop immediately and continue to use after the temperature drops. Today, let's make a brief introduction to the correct use of radiator of automatic feeding mixer truck
  1、备用的散热器有效环境应保持通风、枯燥。
  1. The effective environment of standby radiator should be kept ventilated and dry.
  2、建议运用软硬水需软化处理后运用,避免形成散热器内部堵塞及水垢的发生。
  2. It is suggested that soft and hard water should be used after softening treatment to avoid the formation of internal blockage and scale of radiator.
  3、在冬季为避免结冰形成芯子决裂现象,如搅拌车长时间停车或间接停车时,应将水箱盖和放水开关,将水全部放出。
  3. In winter, in order to avoid core cracking caused by freezing, such as long-time stop or indirect stop of mixer truck, the water tank cover and water drain switch should be set to discharge all water.
  4、水位计应每3个月清洗一次或视实际情况,各部件拆下用温水加无腐蚀性洗涤剂清洗。
  4. The water level gauge should be cleaned every 3 months or according to the actual situation, all parts should be removed and cleaned with warm water and non corrosive detergent.
              全自动上料搅拌机
  5、散热器内要放水再灌水时,要先将发动机缸体的放水开关扭开,有水流出时,再关上,从而避免发生水泡。
  5. When the radiator needs to be drained and then filled with water, the drain switch of the engine block should be turned on first, and then turned off when there is water flowing out, so as to avoid blistering.
  6、在日常运用中应随时查看水位,要停机降温后加水。加水时,将水箱盖渐渐翻开,作业人员身体应尽量远离加水口,以防高压蒸汽油加水口喷出形成烫坏。
  6. In daily use, the water level should be checked at any time, and water should be added after shutdown and cooling. When adding water, the water tank cover shall be opened gradually, and the operator's body shall be kept away from the water inlet as far as possible, so as to prevent scalding caused by high-pressure steam gasoline.
  7、散热器不应与任何酸、碱或其它腐蚀性性质触摸。
  7. The radiator should not touch with any acid, alkali or other corrosive properties.
  8、在运用防冻液,为了避免散热器的腐蚀,请务必运用正规厂家生产且契合国家标准的长效防锈防冻液。
  8. In the use of antifreeze, in order to avoid the corrosion of radiator, please make sure to use the long-term anti rust antifreeze produced by regular manufacturers and in line with national standards.
  9、视实际情况用户应在1~3个月间对散热器进行清洗一次芯体。清洗时,用清水沿反进风向侧冲洗。
  9. According to the actual situation, the user should clean the radiator once every 1-3 months. When cleaning, wash with clean water along the side of the reverse wind direction.
  10、在装置散热器过程中,请不要损坏散热带(片)和碰伤散热器,以保证散热能力和密封。
  10. In the process of installing the radiator, please do not damage the strapdown (piece) and bump the radiator to ensure the heat dissipation capacity and sealing.
  正确的操作方式,可以有效进步全自动上料搅拌机散热器的运用效果,一起也可以避免在运用过程中因操作不当而对设备形成的损耗。希望这些常识可以协助我们对设备进行合理的操作以及运用。
  The correct operation mode can effectively improve the application effect of the radiator of the automatic feeding mixer, and also can avoid the loss of the equipment due to improper operation in the application process. I hope these common sense can help us to operate and use the equipment reasonably.
热门产品 / HOT PRODUCT

 

首页 产品 电话 置顶