The automatic feeding mixer has a reducer on one side of the wheel. Let's talk about how the reducer works.
The wheel reducer is the final reduction gear transmission torsion device. The wheel reducer can meet the total transmission ratio under the same conditions, the transmission, transmission shaft, main reducer, differential, half shaft parts, such as load reduction, small size and the advantages of drive axle get more clearance from the ground, widely used in trucks, large-scale mixer vehicles, cross-country vehicles and other large-scale industrial and mining traffic. Therefore, the research on the wheel reducer has very important practical significance and enterprise practicability.
At present, the gear side reducer is used to meet the matching needs of the whole transmission system, and a set of reduction torque gear transmission device is added. It is installed at the power output end of the agitator to reduce the load of the gearbox. The wheel reducer is used to improve the driving force of the concrete mixer, so as to meet or correct the matching of the driving force of the whole transmission system.
The engine ignites through the clutch, transmits the transmission power to the front and rear axles of the main reducer, and then outputs from the main reducer to the wheel side reducer and wheels to drive the concrete mixer. In this process, the working principle of the wheel side reducer is to transfer the speed and torque of the main reducer to the wheel, so that it can reduce the speed and increase the torque, so that the wheel can produce more driving force under the reaction force.
The above is the introduction of the automatic feeding mixer. If you want to know more, please visit the website: http://www.shanqijituan.com